3D Puff Embroidery Digitizing for Hats -How To Do It

Embroidery digitizing for hats is an extremely effective project. The efforts are worth it, but it totally depends on you. In the digital era, Embroidery Digitizing is done through embroidery machines and computer software. It is a digitizer that puts extreme effort to create appealing designs. However, you can do it by hand too. This Embroidery Digitizing For Hats is different from simple designs, and there is depth in the artwork.

Over the past few years, there has been an increasing demand for 3D designs, especially hats. So in this blog, we'll discuss some tips about 3D hat embroidery to better execute and get the best results.

Amazing tips for digitizing 9D Puff Embroidery

Set your machine speed wisely

Determining the perfect speed for your Stich embroidery machine is crucial, as it can affect the performance of the embroidery design. Depending on your order, you will often need to slow down. The maximum speed of each embroidery machine varies. A good way to do this is to do some experiments with different speeds and determine the best speed that will provide the best results.

Your fabric is very important

Consider using a smooth 3D bubble fabric. There are two reasons. First of all, 3D puff embroidery has a higher density of stitches compared to normal designs. Second, when rubber is used, the surface is too sensitive to vibrations in the hoop.

For this reason, chunky, stable fabrics, such as hats, are preferred. Using 3D puff embroidery, noble fabrics like towels don't match. As a result, their own lofts are faded 3D and unable to cater to attractive designs.

Use the correct needle thickness

We recommend the use of sharp needles in 3D Puff digitizing, which can quickly penetrate the foam.

Select your foam

The choice of foam mainly depends on the height of your custom embroidery model. The thicker the foam, the higher the height of the model. However, dense foams are difficult to work with, although they create gorgeous designs. The thicker the foam, the more it interferes with the smooth running of the machine. Therefore, do not choose thick foam.

Increase switch density

In the digitization of 3D puff embroidery, the stitch density is maintained higher than that of ordinary graphic design. When we talk about high density, we basically mean the satin stitch at the top of the design.

There should be a natural thickness under the stitch. Most computerized machines manage a variety of stitch densities, allowing you to close and tighten cushion stitches.

The density of the top satin stitch is higher than under the stitch, providing a pop-up 3D effect for the embroidery design.

Hat 3D Puff embroidery digital with simple tips

Now, we will share with you a simple tip for 3D Puff embroidery digital hat. Many times you will notice that when the 3D foam part is ready, the digitizer picks it up and holds it by hand to manipulate it while sewing.

However, there is a good way to do this. When you circle the hat, take a rubber band and put it on the hat. You don't need a custom rubber band. A simple rubber can do the same thing.

When your design is ready to puff, pick up the puff and place it in place. Take part of the rubber band and put it on top. You are now ready to proceed with the sewing process. After the design is complete, you can remove excess foam.

So, here's the whole process of 3D puff embroidery digitized hats and hacks.